Bending copper pipes

Using bending springs is a simple job which requires little practice to achieve successful results. The spring should be inserted into the pipe so that the middle of the spring roughly corresponds with the proposed bend point. If this means that the spring will disappear into the pipe, attach a length of nylon cord or thick string to help you remove it after the bend has been made. In many cases the easiest way to make the bend is to place the pipe, with the spring inserted, just below your kneecap and, holding it either side, gently pull it towards you.

As it is difficult to correct a greatly overbent pipe by this method, first underbend and then check the angle before proceeding. If the pipe proves too tough to bend this way, obtain a thick piece of wood, about l00mm x 50mm and about 610 mm long, and drill a hole near one end slightly larger than the diameter of the pipe. Chamfer the lower edges of this hole with a suitable tool (the round file will do). Then place the bottom of the wood on,the floor or workbench, insert the pipe in the hole, and then press down on either side. When the bend has been completed, the spring is sometimes difficult to withdraw. This can be overcome in two ways. The first is to insert a screwdriver through the eye at the top of the spring and unscrew it anti-clockwise. The other method is to overbend the pipe slightly, then correct. This loosens the ‘grip’and the spring can then be pulled out.